GeekVape Cutting Pliers

GeekVape Cutting Pliers – Precision and efficiency for rebuildable assemblies

An essential tool for demanding vapers

The GeekVape cutting pliers are a precision accessory for rebuildable vapers. Designed to facilitate the clean and precise cutting of resistive wires when assembling coils on RBA, RTA or RDA decks, they are distinguished by their robustness, fine cutting and ergonomics.

Compact, reliable, and easy to handle, these pliers are ideal for both experienced vapers and beginners looking to start assembling coils. They allow you to cleanly cut coil legs without damaging the deck or creating a short circuit, making them an essential tool in any DIY vape kit.

Technical characteristics of the GeekVape clamp

• Type : Diagonal cutting pliers

• Material : High strength stainless steel

• Handles : ergonomic non-slip plastic coating

• Total length : compact, usually less than 13 cm

• Sharp blade : suitable for fine to medium resistive wires (Ni80, Kanthal, SS)

• Use : cutting resistive wire or coil tab on rebuildable plate

The beveled blade allows for a very close cut to the fixing screw, without leaving any excess metal. This feature is essential to ensure a clean and secure installation.

A clean and secure cut for a flawless assembly

The GeekVape Wire Cutter is specifically designed to meet the demands of coil assembly in rebuildable atomizers. Its main advantage lies in its ability to precisely cut wire ends, even in hard-to-reach areas such as postless decks or compact bases.

The thin blade allows you to get as close as possible to the screw without risking damage to the threads or the base. This clean cut is essential to avoid unwanted contact between the coil leg and the chamber, which could cause a short circuit.

Ergonomics and ease of use

Thanks to its non-slip handles, the pliers offer an excellent grip. The pressure applied is distributed evenly, allowing for prolonged use without fatigue. Its small size and light weight make it easy to carry, store, or integrate into a dedicated vaping maintenance kit.

The integrated springs ensure automatic opening after each cut, improving the fluidity of the gesture and facilitating precision work, even with one hand.

For what uses and what types of wires?

The GeekVape wire cutters are designed for cutting resistive wires used in resistor assemblies:

• Kanthal A1

• Ni80 (Nichrome)

• SS316L stainless steel

• Single or twisted wires up to a certain diameter

It is ideal for fine to medium wires, typically used in standard 24-30 gauge assemblies. For complex wires such as aliens, fused clapton, or very thick resistors, the use of a more reinforced plier is recommended.

Good practices and precautions

To extend the life of the clamp and ensure optimal performance:

• Do not use for cutting hard or non-metallic objects

• Avoid leveraging with the pliers, as this may damage the blades.

• Clean blades regularly after use, especially if there is any wire or oil residue present.

• Store the tool in a case or toolbox to prevent deformation or oxidation

When properly maintained, these cutting pliers can last for several years without loss of effectiveness.

Why choose GeekVape cutting pliers?

• Cutting precision suitable for reconstructable

• Thin blade for cutting close to the board

• Optimized ergonomics with non-slip handles

• Robust and durable material

• Ideal for standard wires and common assemblies

• Compact size, easy to carry

• Spring-assisted opening for smooth handling

• Essential tool for rebuildable vapers

Conclusion

The GeekVape cutting pliers are a precision tool designed for vapers passionate about rebuildable vaping. Their ability to cut coil legs with finesse and safety, their practical size, and their robustness make them a must-have in any assembly kit. Whether you're a beginner or an experienced crafter, they'll accompany you in all your projects, providing reliability and ease of use. When used correctly, they guarantee clean, safe, and efficient assemblies every time.